...
| Anchor | ||||
|---|---|---|---|---|
|
| Table of Contents | ||
|---|---|---|
|
Overview
Using either the drill down hierarchies or related reports option you can setup drill on charts. This allows users to click on a specific chart section and drill down or through to a related report for more detail. Using this option you can setup charts that drill into more detailed charts or tables, providing users with a greater level of data analysis.
Supported Charts
Below is a table of drill functionality by chart type.
Note: All charts can use Link To drilling.
Chart | Drill Down | Drill Through | |||||||
|---|---|---|---|---|---|---|---|---|---|
Analytical |
|
| |||||||
Scatter |
| ||||||||
Histogram | |||||||||
Box & Whisker | |||||||||
Trellis | |||||||||
Heat Grid | |||||||||
Area |
|
| |||||||
Area | |||||||||
Stacked Area | |||||||||
Bar |
|
| |||||||
Horizontal Bar | |||||||||
3D Horizontal Bar | |||||||||
Stacked Horizontal Bar | |||||||||
Horizontal Cylinder | |||||||||
Proportional Bar | |||||||||
Column |
|
| |||||||
Vertical Bar | |||||||||
3D Vertical Bar | |||||||||
Stacked Vertical Bar | |||||||||
Cylinder | |||||||||
3D Stacked Vertical Bar | |||||||||
Layered Bar | |||||||||
Combination |
|
| |||||||
Combined Category | |||||||||
Overlay | |||||||||
Financial |
|
| |||||||
Financial Line | |||||||||
High Low | |||||||||
Candlestick | |||||||||
Line |
|
| |||||||
Line | |||||||||
3D Line | |||||||||
Z | |||||||||
Stepped Line | |||||||||
Map |
|
| |||||||
Raster Map | |||||||||
Google Map | |||||||||
GIS Map | |||||||||
GIS Bubble | |||||||||
GIS Heat | |||||||||
Meter |
|
| |||||||
Meter | |||||||||
Thermometer | |||||||||
Dial | |||||||||
Numeric Display | |||||||||
Pie |
|
| |||||||
Pie | |||||||||
3D Pie | |||||||||
Multi Pie | |||||||||
Ring | |||||||||
Special Purpose |
|
| |||||||
Funnel | |||||||||
Proportional Infographic | |||||||||
Comparative Infographic | |||||||||
Radar | |||||||||
Waterfall | |||||||||
Event | |||||||||
Week Density |
| Anchor | ||||
|---|---|---|---|---|
|
* This is only available on the Size component of a Scatter. If no size is defined then Drill Through will not be available.
Setting up Drill Down & Drill Through
Chart drill functionality inherits the drill parameters of the report. Use the standard drill functions to setup the drill parameters for a report.
See Drill Down and Drill Through for more information.
Note: Ensure that the report drill through parameters and fields are the same that are used in your chart.